7/13/04
(you can make it as long as you like but remember it attaches under neath the barrel and the longer the more weight)
2) PVC cap to go on end of PVC tube....
3) 3/4" high flow ball vavle....
4) Co2 quick change adaptor....
5) Purple primmer and cement (you can find this in the plummer's section of any hardware store)
6) 3/4"copper or iron pipe (if you use copper you will have to put threads on one end)
7) teflone tape (plummers tape)
STEP 2) put the pipe (copper or iron) into the hole.. the pipe should stick of the other end of the cap about a 1/4"
STEP 3) Take the purple primmer and apply it on the inside(around edges were pipe comes through) and outside of cap, then apply the cemment to same area. Let dry for 1 hour
STEP 4) Glue the cap to the end of 2" PVC pipe(use same procces as above)
STEP 5) Wrap the threads of the copper or iron pipe with plummers tape, screw on ball valve to pipe.
The firing mechinism is now complete. Next few steps are about how to attach it to gun.
You can attach it any where on the gun, my suggestion is under the barrel.
First method....
STEP 6) get some 1" scope rings and attach them upside down on your barrel.
STEP 7) on the part of the scope rings that attaches to the dovetail of a gun, tighten down the bolts on a scrap piece of wood.
STEP 8) use those plastic tie straps you get at grocery stores and attach your home made low budget grenade launcher to the piece of wood.......
(TIP) if you deside to to go out on the field with it already in the launcher put a single piece of tape over the muzzle of the launcher to hold in the shell, don't forget to take it off before you fire. Good luck....