Now I know what your thinking, What the hell is this guy talking about?... well I’m going to tell you.
You know those big gothic boots you can get at Punk/Goth stores, like… everywhere for about $80-$200…
well, if you can find some nice steel toed black boots, and they NEED to be black, or the colors will just look messed up, and everyone will be looking at you like “what the fuck?”
the boot NEEDS to have an inside liner that you can remove and put back… and you have to get one size too large… go for something on sale in case you mess up with your drilling, and YES I said drilling!
You will need:
2 three inch long silver spikes, with threads on the end
4 silver bolts that fit the spikes
4 three inch long silver spikes with threads on the end
8 silver bolts to fit the spikes
4 two inch silver screws with threads that go from the tip to the head
4 silver bolts that fit on the screws
a small tube of silicone
note: all of these will need to be razor sharp and probably made of steel, as long as it won’t rust, and isn’t too soft, as they will go through a lot of wear on your feet.
Get a power drill with one drill bit for each screw/spike size that is as close to the size of the spikes/screws as possible, if not slightly larger, though it is better to drill too small and have to make it larger then to drill too big… since you can’t make it smaller.
take the liner out of the boots
use a piece of chalk to mark your hold for each spikes placement, remember, you want them spaced evenly, or it will look like you did it yourself, and that’s just bad…
the largest spike should be right in the middle of the toe of the boot for the maximum force when you kick
then as the spikes get smaller, and leave lesser holes, you get to the screws…
the screws need to have their edge on them so when you kick the person it snags, therefore tearing the tissue as you pull your boot out.
You will need a small pair of pliers that can fit inside your boot to tighten the spikes, and a small screwdriver to put the bolt on your boot… And don’t forget to put some silicone on the outside of your boot where toe spikes/screws enter to stop water from seeping in. do not turn the pliers or screwdriver in your boot! Use another pair of pliers on the outside, you will get less frustrated.
And when you’re done… remember… if someone attacks you DO NOT KICK ONCE!!! They can still get up, even if it is muscle damage, it’s still minimal… kick them at least 5 or 6 times, and when they fall to the ground kick them in the ass… the muscle damage there will stop them from being able to stand, or walk/move… they will need surgery to move again… then it’s as simple as dropping a smoke bomb and making your escape…
