|
My NEW site is now at, mazzagliatools.com Please make note |
|
Item # EXP-2 Bearing Pin EXP-2 Tired of sanding dowels that don't fit right, and spin in the hole or pop out! This little Brass gadget stays in place, as its rubber base expands in the hole using one hand. Comes with one 10 foot length of bearing string attached. $10- Extra Rubber ends, with screw..........$3- ea |
|
ITEM # BS02 Bearing String This string is super strong and smooth for sharp, clear sighting over the gauges. 30 foot spool Only $5- |
|
Item # CW-22 Bridge Capping Washers Basic flat or fender washers, only put pressure near the base of the screw. Capping washers distribute pressure to a wider surface area on the cap because they are 1-1/2"x 2" Brass 1/4" thick, and relieved in the center, allowing pressure near the edges first, giving you a better glue joint! Set of 5- $35 |
|
ITEM # TP02 Bridge Pin Tri-Punches Marking bridge pin holes has never been easier. The set includes six Brass punches, four tri-pin punches as follows, 11/32" 3/8" 13/32" 7/16" and one 5/16" bi-pin punch and a single punch. . Clearly numbered in fractions. 6-punch Set $85 Handstitched Leather Pouch Included |
|
ITEM # BC 06 Bridge Capping Table $210- Keeps crown in the bridge while gluing new caps on. Easily assembled, made of solid 3/4" HDPE. Glue WON'T stick to this. The 8-Foot rails are crowned, with 20,- two foot cross rails to C-clamp on. Makes an awkward job easy to handle! (easy to assemble) |
|
Bearing and Bridge Tools |
