1200°C Vacuum Heater System Specifications
| Home | Specs | Performance Data | Vacuum Chamber | Monitor Unit | Power Control | Video System |
| Operating Temperature | 1200°C (1300°C max due to materials limitations). |
| Vacuum Environment | 10E-3 torr or lower. |
| Temperature Stability | Within 3 degrees at 1200°C. |
| Heater Power | 150 watts at 120VAC, single phase. |
| Heater Filament Life | 10,000 hours at operating temperature and vacuum. |
| Heater Insulation Materials |
Free of impurities, consisting only of molybdenum, alumina, nickel and stainless steel. |
| No fasteners were used in the Tungsten heater assembly. | |
| Surface outgasing rate less than 10E-8 Torr-cc/cm^2-sec. | |
| Vacuum System | 3.8 CFM 2-stage Mechanical Pump 1/2 HP, 115VAC, 50/60Hz, Single Phase |
| Water Cooling | None. |
| Cooling Method | Thermal conduction and thermal-vacuum radiaiton. |
| Temperature Monitoring | Two digital meters ( for Type "S" thermocouples) with set-point temperature control and over-temperature limit. |
| Safety | Complies with national and international safety standards. |
| Interlock Protection | Heater power "OFF" should vacuum or temperature exceed pre-set values. Manual push-button reset. |
| Data Storage | Pre-selected intervals into computer memory. |
| Data Monitoring | Vacuum and temperature visually at the system and remotely on a computer terminal. |
| Physical Characteristics | Compact in size. Footprint less than 2 feet square. |
|
Lightweight: 105 pounds. 50 lbs-Instrument. 55 lbs.-Vacuum. |
|
| Mobility |
Moveable on casters with lock. |
| Capable of passing through normal doorway openings. | |
| Facility Power | 20A, 115VAC, 60 Hz, single phase. |
| Noise Level | -48dB (approximately). |
Designed and Manufactured
by J. L. Tom Engineering.
