The focal point of the shop is the Robland X-31 which is located in the center of the floor.  This particular machine is almost 10 years old.  The original adjustments are still in use today.

Home

The Outfeed table shown in this photo was shop built from scrap 4/4 and 8/4 maple.  It provides an extra 4 feet of support for the stock when ripping long boards.

Shop

Machines

Projects

Jigs

Against the wall on the right is a maple bench, where most of the dry assembly and final fitting takes place.  This bench is patterned after the one described in Issue 50 of  "The Wood Smith" magazine . Note the quad boxes mounted on each side of the bench.  These provide 120V at 15 and 20 Amps.  The Quad box on the far right provides 240V at 15 and 20 Amps.

Any questions or comments contact me.