Axle, Transmission & Transfer-Case Modifications and
Repairs and used parts For-Sale..
on December 16th, 2006
for $100.00, plans include
convert to a 4x4 Dually with
4 wheel disc brakes. Using a
Sterling 10.25 rear with 4-link, Dana 60 front with Hydraulic
assist steering and a Dump
Flatbed. A 300 straight-6 with
3 x 1 carbs, Granny 4-speed
and my old Dual-Transfercase.
Build-Up Page 1
Build-Up Page 2
New Painting Cab/Front Clip
Flatbed Re-build
Wheels and Tires
Parts Truck (New Cab)
adaptor i made, it's the low range
section of a GM NP203 and a Ford
Bronco Dana 20 combined for a
4.92 to 1 low range.
Updated 27 May 07
Converted to Divorce mount!
and single to dual wheel. Using a 4-link with Air Baqs and a '08 factory Ford differential cover.
Stock 258, Dana 300/ Dana 30AMC 20, (swapped in T-5)
2"lift/shackle reversal. 32 x 11.5 A/T BFGs on factory
wheels. Has front and rear seats, carpet, bikini top and
windshield with frame, from a '95 YJ Windshield
Dana 44 rear with 30-spline axles. SOLD
using rubicon express brackets, factory disc
brakes and Air Locker installation.
with a Dana 44 front, and i swapped in a Dana 60 (a Dana 61 out of a D600 truck) and Dana 60 rear, both are
open with 3.54 gears. It's got a 318, NP435 and a NP208.
W250 with 1-ton front
$2500 obo....
HUMMER wheels
& 38 x 12.5 16.5 TSL's
5.86 ring and pinion with welded differential
(pictured) and a 3/4ton disc brake swap.
was the 4th front axle in my jeep, now it's
in a '52 Ford. The center section is from a '77 Ford F-250, it has Dodge dually outers.
I narrowed it 6" and corrected the caster.
a little info on this in-famous tranny.
bought in San Diego, CA in '91, drove to Pensacola, FL.
then Norfolk, VA. shipped to Sicily Italy, and back to
Milton, FL. finially calling Pennsylvania home.
Now being Parted out; E-mail me if your looking for a
vortec V-6 and TH350, other misc. 89 YJ parts
Installation on dana 44 and dana 60's
Information on common
transmission swaps also.
CJ factory springs with a BDS Add-A-Leaf to increase
payload. I've also made a "Limiting Strap" connecting
the top of the differential housing to limit droop.
Narrowed housing on right side
@ 2", rotated knuckles to get
pinion up, 4.56 gears with a
Detroit Locker. SOLD
older buildup; Closed knuckle
65 Ford Dana 44 narrowed 6"
maintained, changed offset of wheels to match
YJ track, (also have 2nd set custom wheels
for state Inspections :) Buckshot Mudders.
check out 1/2 to 9/16 wheel studs
"Detroit Locker" with 4.56 gears SOLD
4-Speed (NP435), 4x4 (np205).
Sold.......
Quad-Cab short bed; 5.7 Hemi, G56 manual 6-speed, NV271
transfer-case, AAM 9 1/4" front, 10 1/2" rear with 4:10 gears.